Corflex Inc - Application Instuctions

1. Grasp top of support (largest end) and loosen straps.
2. After determining side of kneecap (patella) that requires support, position buttress on affected side and slide sleeve over knee. (Note: buttress may be removed and placed on opposite side.)
3. Make sure seam is placed posteriorly in back of leg and hinges or spiral stays are placed medial/lateral on leg.
4. Your kneecap (patella)should be centered in the circular opening with buttress placed on rim of the kneecap (patella).
5. Grasp both small straps above and below kneecap by hook tip and pull back onto loop portion of strap.
6. Adjust small straps to desired tension or comfort level.
7. Starting with large strap nearest foot, secure strap thru buckle and tighten to desired comfort level. Secure remaining strap in same manner.

669 East Industrial Park Drive - Manchester, NH 03109
Phone (603) 623-3344 - Fax (603) 623-4111 - www.corflex.com

© Corflex | The advice and information contained in this document is not intended as a substitute for medical counseling.
If you have any questions about treatment for a specific condition, please check with a health care professional.