1.	Release Velcro closures, open orthosis and lay flat.
2:	Note: rigid inserts may be removed from pockets, heat molded to specifications, and reinserted or it may be used without inserts.
3.	Place anterior (low profile) panel on center of abdomen, making sure loop portion is facing outward and curve is facing down.
4.	Place posterior panel on center of back, making sure Corflex logo and elastic double-pulls are face outward.
5.	Grasp both ends of posterior panel, bring forward, and attach to loop on anterior panel.
6.	Grasp both ends of elastic double-pull, pull one side across and attach onto loop area on opposite side of posterior panel, pull other side across and attach to loop area on opposite double-pull.
7.	Adjust to desired tension, making sure not to over tighten.

669 East Industrial Park Drive - Manchester, NH 03109
Phone (603) 623-3344 - Fax (603) 623-4111 - www.corflex.com

© Corflex | The advice and information contained in this document is not intended as a substitute for medical counseling.
If you have any questions about treatment for a specific condition, please check with a health care professional.